|
|
|||||
Some photos and a few notes on this controller:
Right analog stick is at end of a shaft and is actuated by moving the unit against your leg.
At least I found some slick black ribbon cable to use on the unit.
Here I am pointing at the controller so you can see the hand strap. Sorry I didn't shave.
End view of the unit before I put on the right analog stick stalk. I used the original Xbox buttons this time (X Y B A) but used tact switches under them instead of the silicon domes.
The unit comes apart into 2 pieces that connect with Velcro. Thus you can adjust how the pieces go together to fit your hand.
Here's the inside of the trigger box. Springs from pens I had laying around (cheaper than new springs at the hardware store) give tension to the white-colored analog triggers. I filed down the original analog trigger assemblies and drilled small holes for the spring to catch onto.
The back of the original circuit board. I used an IDE cable connector, and it used every pin. Charge And Play port, headset jack are left intact.
|
|||||
