I am working on a third revision VCSp, as you may know. The purpose of this unit is to simplify construction time, which means a lower price when I sell it.
Using the same TFT active matrix screen as the first 2 Atari portables, I believe I can get the price in at around $300.
I also might look into some cheapo pocket TV’s they have at Radio Shack. If those TV’s work, they would bring the price down to around $240, although it seems Radio Shack is phasing them out, so it’s up in the air.
Lastly, if people were to send me an Atari 2600 4-switch to gut, that would take an additional $40 off the price.
One reason I’m pushing using a rechargeable battery on these things is because doing hookups for ONE battery is a lot simpler than doing hookups for FOUR batteries. (especially that 9 volt, it’s a bugger) Again, that saves time and money.
These prices allow me to make a little profit off each unit. Not enough to become rich by any means, but enough to not go in the hole. I won’t know for certain until I complete VCSp Revision 3, but I thought I’d announce my cost estimates now to see what people think.
I have been trying to figure out what sort of power source would be best for the VCSp’s that I want to sell. They currently take (3) AA’s and (1) 9 volt. I was thinking that it might be better if they took rechargeable camcorder batteries. (like the Vagabond plans) These batteries would cost from $40 to $150, depending on how much power / time you wanted. Best of all, they’d be rechargeable. I’d probably just let the VCSp buyers purchase their own and stick them in.
I guess the only issue here really is cost. Course, run through about 7 or 8 sets of batteries and you’ve got the $40 cost of a rechargeable.
I’d like to know what people think, I’m too lazy to set up a poll so please drop me a line and give me your take on the whole rechargeables VS non-rechargeable thing. Thanks!
A major stumbling block in my quest to build Ataris is the cost of the screens. As far as screens go, there are two choices.
Pocket TV’s have 2.5 to 3 inch screens, which is a good size, but since they can also receive TV signals they have a lot of excess circuitry and that wastes space.
Modular screens usually just have video IN jacks, they can’t receive TV signals off the air. And that’s fine, because all these portables use are composite video signals. But most modular screens don’t come smaller than 4 inch, and a lot of them use 12 volt power. That screen size is too big and 12 volts is more power than a portable can manage.
So if anyone has info on modular type screens that can accept a composite video input and don’t have much excess circuitry, I’d be very grateful if they could drop me a line. Ideal screen size would be from 2.5 to 3 inches diagonal. Ideal power consumption would be 5 volts or less, but as close to 5 as possible. This is part of my effort to bring down the price of Atari portables, and any help would be appreciated. Thanks.
NOTE – Game Boy / Game Gear screens will not work without modifications. I’m looking for info on small television/monitor screens only.
We’ve (sort of) got a new look! I thought the site’s home page needed to be updated somewhat to accommodate more for the ‘news’ aspect of things. Now, the news you need is right near the top! And check out those cool buttons to the right! I did them myself! (In my other life I’m a graphic artist you know) I think they look more professional than the old ones (and they load slightly faster as well).
I’ve created a new section “VCSp Models”. It discuss the current revisions of portables I’m working on. Revision 1 being the original VCSp, Rev 2 being the blue one I’m going to sell (see below), and Rev 3 being the next version, hopefully smaller, faster, cheaper. The super-entertaining story behind the first VCSp can be found there, as well as lots of details on the new models.
The Vagabond section is the same as before… I’m still working on it, but it has taken a backseat to (Not-so) Secret Project X, which is my plan to mass-produce VCSp’s. I think people will agree with my priorities on this one. The Vagabond will be cool, but it will only benefit me. If I can make lots of VCSp’s, that will benefit other Atari lovers. So for now that’s my main goal.
A word of clarification on the unit types. The Vagabond is a much smaller type of Atari portable. It has a bigger screen, however. Also, it uses the newer Atari 2600 Junior board inside. It runs off rechargeable batteries similar to a digital camera. It’s functioning but the casing is not finished yet.
‘VCSp’ refers to the original portable I built, and the newer ones that I am trying to mass-produce. These are easier to build since they aren’t as small and compact as the Vagabond.
Last week I mentioned something I was working on called ‘Secret Project X’. Now, it is finished:
As you can see, it is another Atari 2600 VCSp. It’s not quite done, another day or two… still needs a few things. This is part of a process I am working on to simplify construction so I can build these things in a short amount of time. Most of the changes are internal, and they help a lot. I came across a new type of material called “Densitec” which is a type of plastic. Naturally, the first thing I thought of was Ataris, so I did some tests. The Densitec can be routed very quickly, almost twice as fast as I was able to rout the case for the original VCSp, and it is much stronger. Also you can see it has a nice ‘texture’ to it, like an Atari. The sample material I had to work with was BLUE, hence the color of this case. I can order this material in BLACK, but since it’s kinda spendy (have to order a certain amount at a time) I want to see how things go first.
By ‘how things go’ I mean the sale of this unit. That’s correct, this unit is FOR SALE. It was built with one thing in mind – to be sold to some lucky Atari enthusiast. It will probably go on eBay in a few weeks. And then, if I find interest to be strong enough, I will order additional material and start building even MORE of them. And then they will be colored black, don’t worry!
This is Phase 1 of a plan that I have for bringing these portables to the masses. I welcome any suggestions or questions you might have, so please email them here.
Now that I have finished my movie, I can get back to the important stuff: ATARI! Some recent developments have led me in a certain direction… For the past week I have been working on SECRET PROJECT X! Not only to give me a break from the Vagabond, but for the betterment of Atari-dom!
I am about 60% through SECRET PROJECT X, and I should know by January 19th-ish if it’s going to work. If it does, it will answer the most frequently asked question I’ve had…
The last update of the millennium, millennium, millennium!!!!!! It’s been interesting these past months, seeing the level of support for an Atari 2600 portable. For some odd reason I thought I was the only one left who cared about Atari! As we move into a newÂ millennium millennium millennium , I hope I can bring the Atari-loving community more treats… The Vagabond, perhaps an extra Atari unit I could sell on eBay, and future 3rd generation units. I think there’s a market for this stuff and I’m going to do my best to pursue it… People watch old movies. Why wouldn’t they want to play old videogames? At any rate, thank you all, and here’s to the future! (glug glug!)